How to install MemberSpace on Framer

Installing MemberSpace on your site

  1. Copy the install code from your MemberSpace backend:

    If you're an Agency setting up a site for a client, or if you're re-installing MemberSpace on a site you previously connected, you can locate the install code here.

  2. Make sure you are logged into your Framer backend (you'll need to be subscribed to the Framer Mini plan or higher to install MemberSpace).
  3. From your Framer dashboard, click into your site. Then, click the dropdown at the top, left > Site Settings > General:

  4. Scroll down to Custom Code, and paste what you copied into the Start of <head> tag section. Then, click Save

    Don't forget to Publish your changes.

  5. Finally, go back to MemberSpace and click Verify Install:

    If MemberSpace is installed correctly, you'll see a green "Successfully Installed" message appear next to the Verify Install button.

    If MemberSpace is not installed correctly, you'll see a "Not installed yet" message. You may need to walk through the steps in this guide again to be sure the install code was successfully copied and pasted into the correct place in your website backend. 

  6. Once MemberSpace is successfully installed, people can visit your website and join your Member Plans to get access to your Member Pages!
  7. To test this, you'll need to be on your live website (not the Framer editor).

Once you successfully install MemberSpace, your Member Button will automatically display in the bottom right corner of all your website’s pages. If you'd like, you can customize or disable the Member Button.

Locating the install code in your MemberSpace backend

  1. In MemberSpace, click Customize > click Integrations > click Custom HTML.
  2. Click the Copy button:

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us